Latest
FAQ: What do the different sensor lights mean?
By
Laurie Tyrrell-Schroeder, DVM |
Updated on
|
Equipment,
Instrumentation,
Locked,
LT Schroeder,
Sensor Guidance,
User Tip
Turning on Sensors: Green LED flickers (blinks) at a fast rate: Magnet is Turning Sensor On or Off Green LED flickers at a moderate, steady rate: Ready to connect Green LED solid or flickering (blinking) at a slow rate / doesn’t respond to magnet: Connected to Lameness Locator Green LED flickers momentarily and shuts off: Needs charged You followed the instructions on how to turn on your sensor, but the Green LED doesn’t appear: Needs charged On Charging Station: Red LED is Solid: Charging Red LED light turns off: Fully Charged Sensor is properly placed on station, but Red LED light does not turn on: Contact Us
User Tip: A Word about Sensor Charging and Battery Care
By
Equinosis Staff |
Updated on
|
Equinosis Staff,
Equipment,
Locked,
Sensor Guidance,
User Tip
Many customers ask about sensor life, routine charging, and what to expect as the sensors age. Equinosis sensors are made with Lithium Polymer batteries currently manufactured by PowerStream. Lithium Polymer is a higher quality subset of a broader class of Lithium-ion (Li-ion) batteries. The component used has a specified life of 500 cycles - where after 500 cycles, greater than 70% of initial capacity is retained during laboratory testing conditions. However, in the field, “cycle” is an elusive term as it depends on several factors. And 500 is even more elusive as that is a lower specification limit. So, the average...
FAQ: How do I turn on/off Gen5 sensors?
By
Laurie Tyrrell-Schroeder, DVM |
Updated on
|
Equipment,
Instrumentation,
Locked,
LT Schroeder,
Sensor Guidance,
User Tip
Please be advised that some Generation 5 sensors may turn on differently than your other sensors, depending on the ship date of your original sensors. TO TURN THE SENSOR ON: wave/pass magnet near the Magnetic Switch until the Green LED starts to blink. TO TURN THE SENSOR OFF: HOLD the magnet STEADY in the same area for approximately 6 seconds.
User Tip: Bluetooth & Sensor Connection Guide
By
Kevin G. Keegan, DVM, MS, DACVS |
Updated on
|
Bluetooth Troubleshooting,
Equipment,
Instrumentation,
KG Keegan,
Locked,
Sensor Troubleshooting,
User Tip
If you ever have trouble connecting to your sensors or experience sensor lag (sensors plotting asynchronously across the screen) as horse gets farther away, the following is a quick check list to run through for possible reasons. For more in-depth troubleshooting, click HERE to view the complete Bluetooth® Sensor troubleshooting guide. Check that your sensors are sufficiently charged and turned on. If you have more than one set of sensors in your system, make sure you are attempting to connect to the correct set. If any sensor is a new replacement, the sensor must be programmed into the system (contact...
All
FAQ: What do the different sensor lights mean?
User Tip: A Word about Sensor Charging and Battery Care
FAQ: How do I turn on/off Gen5 sensors?
User Tip: Bluetooth & Sensor Connection Guide